DVT Solutions LLC is partnering with Giga Connections inc. to apply Gold Plated Conductive Diamond (GPCD) particles to the GigaProbes™ probe tips. This forms a superior, multi-point diamond connection system on the rough surface that can pierce any contaminants on either the DUT leads or test contacts. The resulting contact resistance is fewer than 5 milliohms with no measurable inductance or capacitance after thousands of mate/demate cycles. This controlled impedance material is electrically invisible, requires as little as 10-15 grams contact force, and resists oil and dirt contaminates. Conductive Diamond Plating has been used in military systems, including super computers and satellites, while meeting all military environmental specifications. When used as contacts on interposers, The GPCD enables 10 to 40 Gbps devices to perform the same or better within RF test socket, CPU scoket applications than if they were soldered directly to the board.
1000's of Conductive Diamonds on Probe
Full Gold Plated probe and Conductive diamond/Gold Plated Probe Tips
Gold Plated Conductive Diamond Applications
Giga Connections will contract with PCB board houses to plate their boards. Please call 650 593-7083 or Email for quotes
Giga Connections Inc. 40 GHz interconnects technology deposits 1000’s of Very Sharp, Non-Oxidizing, and Conductive Gold Plated Diamonds on surfaces to be connected. This Creates a 40 GHz Board to Board Connection.
BENEFITS
Highly reliable connections:>100,000 mate/de-mate cycles without measurable degradation in signal integrity.
Small pitch: Plated contact pad size of 5um (4 mil pitch) can be achieved
No scrubbing necessary:Easily breaks though surface oxide; creating a temporary or permanent connection as good as solder
Low mating force required: Decreases necessary minimum force to make low-resistive contact
Below are products where GPCD has been used to improve the performance over standard gold on gold, Delphi Gold Dot or any spring contact interconnects.
Visit Giga Connections, Inc. for more information on this advanced interconnect technology.
Conductive Diamond Interposer in 40Ghz Test Socket
Examples of GPCD interposers
TDR waveform of Test Board with GPCD Socket. The end of the waveform shows almost no impedance discontinuity where the BGA ball and GPCD interposer connects.
10Gbit PAM 4 eye diagram as measured through the GPCD Test Socket. Signal integrity performance as if the device was soldered to the test board. Save money from developing additional test boards.
Board on Board Diamond Interposer
Flex with Gold Plated Conductive Diamond pads
Clos-up of Flex Gold Plated Diamond pads
Copyright 2006 Brian Shumaker DVT Solutions 650 743-5669
